For sure! As far as process, I came up with the layout using keyboard-layout-editor.com and from there I designed the PCB in KiCad and the switch plate and case with Fusion 360. The case took a lot of trial and error to get everything fitting right so I made a lot of 3d printed prototypes before I was satisfied with it. After I had my printed prototype done I basically went on Alibaba and searched for manufacturers who had keyboard cases listed as products they could make and I messaged a bunch of them asking for quotes on 1, 3, and 25 cases (I was trying to decide on 1 or 3 prototypes and then 25 will be the minimum order quantity if it makes it to group buy). The one that gave me the lowest price was also the company that someone I've been getting advice from has used on group buys he's done, so I ended up going with them since he vouched for their quality.
The cost goes up quite a bit as the order quantity decreases, so this prototype was expensive. After shipping and fees and everything, it was over $600. I probably wouldn't have paid it if I hadn't just gotten a tax refund honestly. Some of the other manufacturers that I talked to had slightly lower prices for smaller order quantities but they were too expensive for the group buy quantity.
When you hit Q, A, and Z at the same time it spits this out