this post was submitted on 22 Jun 2023
65 points (100.0% liked)
3DPrinting
15396 readers
43 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's not just the nozzle size alone. Each hotend has a limit to the volumetric output, how much plastic it can melt in the time it takes the filament to travel through the hotzone in a certain time, which is roughly calculated by line_width x layer_height x print_speed, e.g 0.6 x 0.3 x 50 = 9. That the limit is varies depending on your print temperature and it also isn't linear - you start underextruding up to 50% before you hit the point where the extruders starts skipping for example - but there is a limit - for standard hotends it's usually around 15mm^(3)/s.
https://www.cnckitchen.com/blog/flow-rate-benchmarking-of-a-hotend