Here's my 3D printed mini network rack.
It uses a TP-LINK TL-SG108 switch, a DIY patch panel, and a Raspberry Pi running PiHole. Here's the stl files if you would like to 3D print one yourself.
this post was submitted on 20 Jun 2023
35 points (100.0% liked)
homelab
6522 readers
18 users here now
founded 4 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Funky! I love it. What’s the story on the DIY patch panel? Did you 3D print the chassis and then pop in RJ45 keystones?
For the patch panel, I had to 3D print the panel a few times to make sure the RJ45 jacks fit properly. It took a few tries.