I bought this used desk a week ago; it had been disassembled and sitting in storage. While bringing it home, some of the cam screws got bent quite a bit to the point where I can’t fit them into the actual locking part of the screws.
The only solution I can find is to replace all the cam screws and locks, but the screws have what seems like a drywall hook on them? It’s making it impossible to take them out, plus they don’t have a screw head visible instead it’s just a little hole.
Does anyone have an idea on how to take these out so I can replace them, or any other ideas how to get this desk together? I think the actual locks are worn down as well, since the only piece I could get attached wouldn’t actually lock into place.
Worst case, cut them off and drive screws from the other side of the board.