Ask Electronics

3173 readers

13 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago

MODERATORS

[email protected]

What's a good method for a non-technical person to short the terminals of two 0402 resistors ~1mm apart? (lemmy.world)

submitted 1 week ago by ch00f to c/[email protected]

27 comments fedilink hide all child comments

I'm working on a mod kit for a popular item, but my target audience isn't likely to have a soldering iron. The majority of the project connects to an exposed ribbon connector, but I need to short two terminals to force a power supply on.

Any ideas on a method I could provide for people who can't solder? Maybe a strip of copper tape?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 1 week ago (1 children)

Hold a small piece of metal (paper clip?) between solder pads with a tweezer. Heat up tip of a metal fork/spoon (Sharp edge of fork could work better) on a stove. Take it from stove and use it immediately to melt the solder on one pad (seems like there is already enough solder there). I am not sure if it would work but maybe worth trying. Heating entire fork could be hard, so maybe something with smaller metal mass could work better, like a screwdriver, nail clipper etc).

[–] [email protected] 1 points 6 days ago

They've asked for a good method for a non-technical person, not a bad one for a freaking MacGyver.